Big consumers have to use many cylinders. SSFCI CO₂ manifold system enables a consumer to draw CO₂ gas at one place and avoid mishandling of CO₂ cylinders at different places at the workfloor. The battery system of using the cylinders at one place eliminates the carriage of individual cylinders at different locations where MIG welding sets/user systems are located.

The SSFCI manifold system incorporates a special system, through the pipeline laid across machine on the shop floor. With our Pressure Reduction Station the pressure of the gas is reduced so that low pressure gas (as required by the user) is sent through the pipeline. With proper instrumentation and inter-locking, safe system is designed for trouble free service.

CO₂ is transported in liquid phase either in cylinders or in storage tankers but it is used in gaseous state in beverages and other uses.

CO₂ is evaporated and expanded to lower pressure. In the expansion operating cooling occurs which can choke the entire system, resulting in pressure oscillation and thus CO₂ losses can take place.

1. No internal freezing. 2. No pressure oscillation
3. Clean CO₂ as the impurities get filtered off.
4. No interruption in CO₂ supply during cylinder change. Saving of energy, CO₂ and time are the main advantage.
5. No outside heater/steam required. 6. Neat surroundings.
7. No full time operator required.

SSFCI manifold system makes it possible to supply gaseous CO₂ at any desired outlet pressure. We can install up to 4 outlets with 4 different outlet pressure as required. Gas outflow pressure can be varied between 1 to 16 bars. The quality of CO₂ required determines the number of CO₂ cylinders to be connected per hour. Our engineers will erect the complete system for you. The time for installation is minimum as the entire system is pre-assembled and tested at our site.

Since, in many courtries CO₂ supplies are done in the cylinders of different sizes, heights & capacities, therefore, the SSFCI manifold system, is modified to suit such conditions. It must be understood that the system is designed to handle pure, moisture free CO₂ gas as per IS/BS/ASME Standards. If the gas is not of proper specifications and contains moisture or oil etc, extra features like Dryers and Oil Filters can be incorporated at extra cost.

Alarm System can be provided to indicate low pressure in cylinder when these are exhausted.